Skip to content
GCL Room

At the turntable

The Turntable

A turntable is a simple machine asked to do something delicate: drag a tiny diamond through a groove without wobbling, rumbling or wearing the record away. Most of what makes it sound good happens before the music starts.

A stylus resting in the groove of a spinning record
The stylus is the only part that touches the record. Treat it kindly.

Start level

Put a small spirit level on the platter, or on the plinth if the platter is hard to reach. Adjust the feet or add thin shims under the shelf until the bubble sits in the middle in both directions. An uneven deck pulls the arm toward one side of the groove.

Give it a quiet home

Turntables pick up vibration. A solid shelf or a wall bracket keeps footsteps and speaker bass from reaching the needle. Avoid putting the deck on top of a speaker, however tidy that looks.

Tracking weight and anti-skate

The cartridge maker publishes a recommended tracking force, usually as a small range in grams. Balance the arm so it floats level, then set the counterweight to the middle of that range. Many decks have an anti-skate dial; a common starting point is to match it to the tracking force and adjust only if one channel sounds rougher than the other.

Keep the stylus clean

A soft stylus brush, moved gently from back to front, removes the fluff that builds up after a few sides. Never brush side to side, and never touch the tip with a finger.

When to replace it

Styli wear slowly. If familiar records begin to sound harsh or sibilant, or the tip looks chipped under a magnifier, it may be time for a replacement. The manual for your cartridge is the best guide to how long it should last.

These are general notes. Your turntable’s manual always comes first, and any work inside an amplifier or a mains-powered deck belongs with a qualified technician.

Next: Room Sound